Engine Oil Checks

In order to operate the equipment in good condition, the engine oil level should be checked daily before operating the loader.Please check according to the following:

1.Ensure that the loader is parked on a level surface, switch off the engine and wait 30 minutes for the oil to flow back into the sump.

2.Open the engine compartment cover and find the dipstick.

3.Pull out the dipstick completely and wipe the oil from the dipstick with a clean paper towel.

4.Insert the cleaned dipstick into the oil pan again, insert it completely and pull it out again.

5.Observe the oil level of the dipstick after pulling it out.

6.There are XX marks on the dipstick and the oil level should be between the XX marks in this section.

7.If the oil level is close to or below the ‘Bottom’ mark, it is time to add oil.

8.If the oil level exceeds the ‘top’ mark, it is necessary to drain the excess oil.

9.After adding the proper amount of oil to the engine filler neck, repeat the above steps until the oil level is within the normal range.

10.Ensuring that the oil level is within the normal range is an important measure to ensure proper engine operation and avoid engine damage.

11.For our safety, please make sure to check daily.